Kyocera TASKalfa Pro 15000c Installation Manual page 294

Enhancement device setup procedure > Optional device installation
14
Open front upper cover [A]. Install punch dust tank [B].
[A]
15
Put label [C] on the sheet [A] onto the position [B] shown in picture after cleaning
with alcohol.
[B]
16
Close the front upper cover [A].
[A]
Punch position adjustment
Connect the power plug of the main unit to the outlet and turn the power on.
Make test copy in punch mode.
If the holes are out of position then adjust them as following procedure.
[B]
[A]
[C]
3-216
[CONFIDENTIAL]