Kyocera TASKalfa Pro 15000c Installation Manual page 326

Corrective action when service call occur > C2100
4
Remove 4 screws for the image conveying unit and pull it out. (Screw x4)
• If Registration cleaning unit is on the way of the unit then select [Unit Move]/[Storage] in U705 [Registration
cleaning] and press [Start] to execute. (Let the Registration cleaning unit move to storage position.)
5
In case of (1) (2), hold the image conveying belt unit and pull out with the image
conveying unit [A].
6
Pull out the image conveying unit [A] holding handles [B] and [C], and put it on a
table.
[B]
[A]
IMPORTANT
Pay attention when handling the print conveying belt unit, the lift wire might come off if lifting up the lift plate
from the bottom.
[C]
5-11
[CONFIDENTIAL]
[C]