Kyocera TASKalfa Pro 15000c Installation Manual page 24

The main unit setup procedure > Unpacking
6
Cut the tape for the slope to be placed and open the flap [A].
7
Remove 6 bottom pads [B] by lifting up the front and rear of main unit [C] alternately.
1
Lift up both the left and the right handle of the main unit in order and detach the pad located in center.
2
Then next, lift up both the front and back handle in order and detach each 2 pads.
• When working, support the machine not to fall down and be careful not to pinch the hands or feet.
8
Cut off the carton board shown in red frame [D] for placing the slope.
9
Hang pins [B] on the backside of the slope onto bottom plate of the skid then set the
slope [A].
10
Move through the main unit [C] from the skid using the slope [A].
[B]
CAUTION
Do not lift up and move the main unit by holding handles only.
Pay attention not to locate your foot under the main unit in this work.
Do not leave the main unit under sunlight or outside to avoid from deforming the covers.
[A]
[A]
2-8
[CONFIDENTIAL]
[D]
[B] [C]
[C]