Enhancement device setup procedure > Optional device installation
3
Remove the rid [B] from rear lower cover [A] that removed in step 2 (Screw x2). The
screw will use in step 15. The rid [B] will not use in this installation again.
4
Place Fiery Relay PWB [A] by aligning its connector [B] with a hole [C] on the
controller box.
5
Secure the Fiery relay PWB [A] (Screw x2: M3x8).
[C]
3-219
[A]
[B]
[A]
[A]
[CONFIDENTIAL]
[B]