Kyocera TASKalfa Pro 15000c Installation Manual page 49

The main unit setup procedure > Installation
2
Place 2 sheets of paper [B] on the image conveying belt and cover them with 2 sheets
of Kim towel that are folded along with long side.
• The paper has to be Ledger (In case of A3, fold at 30 to 40 mm from the long edge) and place them on cut out
[A] of the cover.
• Kim towel has to be set as folded edge is outside and pile up at center.
[C]
[B]
[A]
3
Push the image conveying unit [A] into the main unit slowly.
• Make sure not to contact the [B] section of the treatment unit when inserting the conveying unit [A].
4
Pull straight out the paper [A] and the Kim towel [B] from the image conveying belt
slowly.
• Pull them a little bit and bring the Kim towel [B] to the center then remover them.
[B]
[A]
2-33
Ledger [B]
[C]
[A]
[CONFIDENTIAL]
A3 [B]
[B]