ZyAIR Wireless Gateway Series User's Guide
Table 28-3 General Commands for GUI-based TFTP Clients
COMMAND
Host
Enter the IP address of the ZyAIR. 192.168.1.1 is the ZyAIR's default IP address when
shipped.
Send/Fetch
Use "Send" to upload the file to the ZyAIR and "Fetch" to back up the file on your
computer.
Local File
Enter the path and name of the firmware file (*.bin extension) or configuration file (*.rom
extension) on your computer.
Remote File
This is the filename on the ZyAIR. The filename for the firmware is "ras" and for the
configuration file, is "rom-0".
Binary
Transfer the file in binary mode.
Abort
Stop transfer of the file.
Refer to section 28.2.5 to read about configurations that disallow TFTP and FTP over WAN.
28.2.9 Backup Via Console Port (only for ZyAIR B-2000)
Back up configuration via console port by following the HyperTerminal procedure shown next. Procedures
using other serial communications programs should be similar.
Step 1.
Display menu 24.5 and enter "y" at the following screen.
Figure 28-3 System Maintenance : Backup Configuration
Step 2.
The following screen indicates that the Xmodem download has started.
Figure 28-4 System Maintenance : Starting Xmodem Download Screen
28-6
Ready to backup Configuration via Xmodem.
Do you want to continue (y/n):
You can enter ctrl-x to terminate operation any time.
Starting XMODEM download...
DESCRIPTION
Firmware and Configuration File Maintenance