Customised Setting Options - Bosch AutoCook MUC6 Series Instruction Manual

en

Customised setting options

Example: Preparation programme
[ steam ] without steam pressure function
W Risk of scalding!
■ Fill with water up to the mark [ 0.5 J ] at
maximum.
■ During preparation, large amounts of
steam may accumulate in the appliance.
Open the lid with care. Do not lean over
the lid of the appliance.
■ The pan and any inserts that are used
may be very hot. Always use suitable
handles or oven gloves.
1. Open the lid of the appliance.
2. Fill the pan with a maximum of 0.5 litres
of water. The measuring scale on the
inside of the pan can also be used to
read the quantity.
3. Hang the bottom part of the steamer
insert in the pan.
4. For steam-cooking different ingredients,
fill the bottom part up to the lower edge.
5. Position the top part and add additional
ingredients.
6. Put the lid on.
7. In function selection mode, select
the preparation programme [ steam ]
X "List of preparation programmes" see
page 26
8. Press button G to start the preparation
programme.
Once the preparation programme ends,
an audible signal sounds and button G
flashes.
9. Open the lid of the appliance.
10. Lift the top part and the bottom part of
the steamer insert out of the pan.
22
Customised setting options
The pre-configured values for the prepara-
tion time and the preparation temperature
or steam pressure can be adapted to indi-
vidual needs and the recipe guidelines.
Setting the preparation time
1. In function selection mode, keep
pressing button D until the desired
preparation programme is selected.
The corresponding LED lights up in the
control panel and the pre-configured
preparation time for this preparation
programme is shown.
2. Press button F once.
The pre-configured preparation time flashes
in the display.
3. Keep pressing button F until the desired
preparation time is displayed.
When button F is briefly pressed, the
preparation time is increased by 1 minute.
The time increases up to the pre-configured
maximum value and then returns to the
pre-configured minimum value. When
button F is pressed for a longer period,
the preparation time is increased by
10 minutes.
4. Once the desired preparation time is
displayed, press button G.
The preparation programme with the set
preparation time is started.
If the time needs to be adjusted individually
for all preparation steps in a selected
programme, then repeat points 2 to 4 prior
to starting the respective preparation step.
Note: These settings are not saved. If this
preparation programme is selected again,
the pre-configured preparation time will be
shown in the display once more.
Setting the preparation
temperature
For preparation programmes without the
steam pressure function, the temperature
can be selected individually.
1. In function selection mode, keep
pressing button D until the desired
preparation programme is selected.