Bosch AutoCook MUC6 Series Instruction Manual page 18

en Preparation
Note: If no input is made on the control
panel within 5 minutes, the appliance
automatically switches to standby mode.
5. Keep pressing button D until the
desired preparation programme is
selected.
The corresponding LED lights up in the
control panel and the pre-configured
preparation time for the selected prepa-
ration programme flashes. The indicator
"low steam pressure" [ K ] or "high steam
pressure" [ L ] lights up. Press button L to
switch between [ K ] and [ L ].
Note: If [ K ] or [ L ] does not light up, the
steam pressure function is not available for
the selected programme.
6. Press button G to start the preparation
programme.
The appliance heats up the pan until the
pre-configured steam pressure is reached.
During the heating phase, lines that light up
in a clockwise direction appear in the display.
Once the pre-configured steam pressure
is reached, the lines go out and the
preparation time is shown in the display.
18
The preparation process starts automati-
cally. The preparation time counts down.
Once the preparation time is completed,
an audible signal sounds, the display
flashes and shows "P". Steam auto-
matically escapes from the appliance
intermittently to reduce the pressure in
the appliance interior.
W Risk of scalding!
Never bend over the appliance while steam
is escaping from it!
When the pressure in the appliance interior
has been completely reduced, the indicator
[ finished ] and button G light up or the keep
warm function is activated.
A rectangle lights up in the display (dotted
lines). The preparation programme is
completed.
7. Open the appliance. Open the pressure
locking handle for this purpose (M)
and press the opening button on the
basic appliance.
Notes:
■ Never use force to open the appliance!
■ Always shake the appliance gently
before opening in order to dissolve any
steam bubbles that may have formed in
the food and to prevent blocking.
■ The pressure locking handle can be
easily opened when the steam has
completely escaped from the appliance
interior and the appliance is fully
depressurised.