Customised Setting Options - Bosch MUC6 Series Instruction Manual

en

Customised setting options

5. Position the top part and add additional
ingredients.
6. Close the lid.
7. In function selection mode, select the
preparation programme [ пароварка]
(steam) X "List of preparation pro-
grammes" see page 22
8. Press button G to start the preparation
programme.
Once the preparation programme ends,
an audible signal sounds and button G
flashes.
9. Open the lid of the appliance.
10. Lift the top part and the bottom part of
the steamer insert out of the pan.
Customised setting options
The pre-configured values for the prepara-
tion time and the preparation temperature
or steam pressure can be adapted to indi-
vidual needs and the recipe guidelines.
Setting the preparation time
1. In function selection mode, keep
pressing button D until the desired
preparation programme is selected.
The corresponding LED lights up in the
control panel and the pre-configured prepa-
ration time for this preparation programme
is shown.
2. Press button F once.
The pre-configured preparation duration
flashes in the display.
3. Keep pressing button F until the desired
preparation time is displayed.
18
MUC6-8_RU_8001018000.indb 18
When button F is briefly pressed, the
preparation time is increased by 1 minute.
The time increases up to the pre-configured
maximum value and then returns to the
pre-configured minimum value. When
button F is pressed for a longer period,
the preparation time is increased by
10 minutes.
4. Once the desired preparation time is
displayed, press button G.
The preparation programme with the set
preparation time is started.
If the time needs to be adjusted individually
for all preparation steps in a selected pro-
gramme, then repeat points 2 to 4 prior to
starting the respective preparation step.
Note: these settings are not saved. If this
preparation programme is selected again,
the pre-configured preparation time will be
shown in the display once more.
Setting the preparation
temperature
For preparation programmes without steam
pressure function, the temperature can be
selected individually.
1. In function selection mode, keep
pressing button D until the desired
preparation programme is selected.
The corresponding LED lights up in the
control panel and the pre-configured prepa-
ration time for this preparation programme
is shown.
2. Press button C once.
The pre-configured preparation temperature
flashes in the display.
3. Keep pressing button C until the desired
preparation temperature is displayed.
When button C is briefly pressed, the prepa-
ration temperature is increased by 5°C. The
temperature increases up to the pre-con-
figured maximum value and then returns
to the pre-configured minimum value.
When button C is pressed for a slightly
longer period, the temperature is increased
by 10°C.
16.07.2015 12:15:10