Table of Contents
Advertisement
3.
Change the contents to be sent.
When switching between "ON"/"OFF" is performed, the changed contents are displayed on the
monitors of external devices. Check for any problems.
4.
Tap [OK].
The Parallel window closes.
I/O Format (Parallel Interface)
Input Format
When the Main screen is displayed, the following commands can be input.
STEP signal
●
Measurement is performed once when STEP signal turns on.
DSA signal
●
When "Output control" is set to "Handshaking", this is a signal to provide notification that the
external device is ready to receive data.
Reference:
Setting Communication Specifications (Parallel Interface) (p.178)
DI signal
●
Commands can be input in the following format.Set 0 (OFF) or 1 (ON) for each DI signal.
Confirm commands and information, and turn DI7 (run) ON with an interval of at least 1 ms.
FZ3 User's Manual
Controlling/Outputting through Parallel Communication
6
181
Advertisement
Table of Contents
