Table of Contents
Advertisement
Important
During parallel continuous measurement and when the STEP signal is input continuously, do not perform
●
switching of the scene group. When this is performed, set "Unchecked" in "Save scene group on switch scene"
in either of the settings items below.
Switch Scene Group window Reference:
●
[Measure setting] in the [Measure] menu Reference: Setting Conditions Related to Operation during Measurement (p.108)
●
SCNLOAD
Reads scene data.
<Command format>
<Response format>
When processing is performed normally
When processing is not performed normally
<Parameters explanation>
Scene No.
Specifies the scene No. to be read (0 to 31)
Specifies the name of the file to be read with a definite path.
File name of
Only files that are under the following systems and have an "SCN" extension can be read.
scene data
- USBDisk
- RAMDisk
Important
If the specified file name already exists, this existing file will be overwritten
●
Do not turn off power to the controller until there is a response.
●
(Example)
When "LABEL.SCN" in the "IMG01" folder of the USB memory to which the drive name "USBDisk2" is
assigned is loaded to the controller as scene 2.
<Command>
FZ3 User's Manual
Switching Scene Groups (p.50)
Controlling/Outputting through Serial Communication (Non-procedure)
6
165
Advertisement
Table of Contents
