Omron FZ3 Series User Manual page 72

2.
From the measurement flow, tap the processing unit to be displayed.
3
3.
Set each item in [Image display] of the Control area.
Item
Image mode
Positions
Sub image
Note
To check detailed results for each unit when "Positions" is on, select any unit after selecting the "Detail
●
result" area to make detailed results active.To make detailed results inactive, select the Image Display
area.
Image Mode List
Changes can be made in the ADJUST window.
Item
Through
Freeze
70 Arranging the RUN Window
This item changes the camera image mode.
Reference: Image Mode List (p.70)
Measurement results are displayed as a list in the Image Display area.
Display contents are classified into "Input image" units such as [Camera Image
Input] and [Camera Switching], and "Compensate image" units such as [Filtering]
and [Position Compensation].
For example, if "Positions" is turned on with [Position Compensation] selected, a
combined positions list for units after [Position Compensation] is displayed. The units
in the area before [Position Compensation] are not displayed.
Indicates displayable image for the selected processing item.
Reference: List of sub image numbers (p.72)
The latest image is always loaded from the camera and displayed.
When "Through" is selected, saved images cannot be called up for measurement.
The image that was scanned in the immediately preceding measurement is displayed. Images can
be updated at any time during measurement.
Description
Description
FZ3 User's Manual