Omron FZ3 Series User Manual page 126

Important
Before setting the communication specifications, set the "Serial (Ethernet) " communication module to "PLC link
●
(SYSMAC CS/CJ/CP/One) ", store to the controller, then restart the system.
Reference:
Use the same communication specification settings for the controller and the external device.
●
When making system settings/Ethernet settings, do not send external input into the Ethernet.
●
1.
On the Main screen, tap the [System] menu - [Communication] - [Serial] - [Ethernet].
The Ethernet window is displayed.
2.
In the communication setting area, set the following items.
6
Setting item
Address setting
124 Communicating through Serial Communication (PLC Link)
Setting the Start-up Status [Startup Setting] (p.112)
Set value
[Factory default]
Obtain an IP address
●
automatically
[Use the following IP
●
address]
a.b.c.d
a: 1 to 223
b: 0 to 255
IP address
c: 0 to 255
d: 0 to 255
[10.5.5.100]
0.0.0.0 to
Subnet mask 255.255.255.255
[255.255.255.0]
Description
Set the IP address of the controller.
When "Obtain an IP address automatically" is
selected, the IP address of the controller will be
automatically obtained.
When "Use the following IP address" is selected,
set the IP address, subnet mask, and the default
gateway address.
Input the controller IP address.
Input the subnet mask address.
FZ3 User's Manual