MULTI-PORT FUEL INJECTION DISASSEMBLY AND REASSEMBLY
INSTALLATION
1. Install IAT sensor in plenum. Tighten 2-1/2 turns maximum.
2. Install plenum, throttle body, throttle cable and flame arrestor as outlined in "Plenum".
3. Connect electrical connector to IAT sensor.
Idle Air Control (IAC) Valve
REMOVAL
1. Remove flame arrestor, throttle cable and throttle body as outlined in "Throttle Body".
2. Disconnect electrical connector from Idle Air Control (IAC) valve.
3. Remove IAC valve from throttle body.
Index
Page 5C-30
Downloaded from
https://needmanual.com/
a -
Plenum
b -
Intake Air Temperature (IAT) Sensor
Refer to "Precautions" in this section, BEFORE proceeding.
a -
Throttle Body
b -
Idle Air Control (IAC) Valve
c -
O-Ring
d -
Screws
a
b
NOTICE
d
b
c
SERVICE MANUAL NUMBER 23
72802
a
72800
90-861326--1 MARCH 1999