SERVICE MANUAL NUMBER 23
11. Install nut and washer to cable barrel stud. Tighten until they contacts. Then loosen 1/2
12. Once shift cable adjustment is correct, secure shift cable(s) with hardware as shown,
NOTE: To change cable approach direction on single or dual station installations, only the
spacer/bushings have to be switched to the opposite stud. The studs are identical.
Index
90-861326--1 MARCH 1999
Downloaded from
https://needmanual.com/
turn.
a -
Cable End Guide
b -
Locknut and Washer (Tighten Until Bottoms Out, Then Loosen 1/2 Turn)
c -
Spacer
d -
Bushings
e -
Cable Barrel
referring to appropriate configuration following:
e
Typical Single Cable - Forward Approach
a -
Cable End Guide
b -
Locknut and Washer (Tighten Until Bottoms Out, Then Loosen 1/2 Turn)
c -
Spacer (Fits Over Bushings)
d -
Bushing
e -
Cable Barrel
f -
Spacers (Fits Over Stud)
g -
Cable Barrel Stud
h -
Cable End Guide Stud
c
a
d
c
b
c
b
72955
HURTH V-DRIVE TRANSMISSION
50229
d
g
h
f
a
b
Page 8D-7
71210