HURTH V-DRIVE TRANSMSSION
Filling Transmission
IMPORTANT: Use only Automatic Transmission Fluid (ATF) as recommended in
"Lubricants/Sealants."
1. Fill transmission to proper level, through oil filter cavity. (Refer to "Capacity.")
2. Install filter as follows:
a. Coat O-ring on filter cover with transmission fluid.
Transmission fluid filter and cover must be properly seated to avoid fluid foaming
and/or loss of fluid, thus resulting in decreased efficiency and/or damage to trans-
mission.
b. Push down until cover is fully seated (top of cover flush with housing), then, Turn
3. Start engine and run for two minutes to fill system with fluid.
Index
Page 8D-12
Downloaded from
https://needmanual.com/
a -
Filter Cover
b -
O-Ring
T-handle clockwise until tight.
a -
Set Screw (Later Models)
a
b
CAUTION
SERVICE MANUAL NUMBER 23
27662
a
27666
90-861326--1 MARCH 1999