CHARGING SYSTEM
8. Position rear end frame and stator assembly over front end frame and rotor assembly
and align scribe marks on each (scribed during disassembly). Hand-press end frames
together, then install four screws. Tighten screws securely.
9. Depress brushes flush with top of brush holder and insert a #54,.050 in. drill bit or smaller
into hole in brush holder to hold brushes compressed during reassembly.
NOTE: Rubber gasket shown removed for clarity.
10. Install brush/regulator assembly in rear end frame cavity and secure with two mounting
screws, as shown. Tighten screws securely. Remove drill bit to release brushes against
slip rings.
Index
Page 4C-26
Downloaded from
https://needmanual.com/
a -
Rear End Frame
b -
Stator
c -
Front End Frame
d -
Scribe Marks
e -
Insert Screws (4) (Two Hidden)
a -
Drill Bit
a -
Brush / Regulator Assembly
b -
Mounting Screws
a
e
c
b
b
SERVICE MANUAL NUMBER 23
d
a
a
90-861326--1 MARCH 1999
72561
72836
72837