SERVICE MANUAL NUMBER 23
3. Place quad ring in groove in seawater pump body.
4. Align flats on impeller and bearing housing shaft, slide seawater pump body on shaft.
NOTE: Reassembly of the pump requires the mounting bracket to be installed while per-
forming the following step.
5. Install two screws in seawater pump body holes as shown. Use these two screws to align
Seawater Pump Bearing Housing
Disassembly
1. Remove gasket, inner wear plate and quad ring seal. Discard gasket and quad ring seal.
Index
90-861326--1 MARCH 1999
Downloaded from
https://needmanual.com/
a
a -
Quad Ring
b -
Seawater Pump
pump, then install the remaining screws.
a -
Bolt Holes For Alignment
a
a -
Quad Ring Seal
a
a
72655
SEAWATER COOLED MODELS
b
75277
a
72656
Page 6A-13