Mercury MerCruiser MCM 454 Mag MPI Service Manual page 884

SERVICE MANUAL NUMBER 23
2. If required, install exhaust tube on gimbal housing as follows:
Exhaust tube clamp may corrode if grounding clip is not installed.
NOTE: Bellows adhesive is not used when installing an exhaust tube.
Index
90-861326--1 MARCH 1999
Downloaded from https://needmanual.com/
a. Remove and discard clamps and exhaust bellows.
b. Install grounding clip on tube.
c. Position tube so that "SIDE" markings on tube are facing toward the right and left
sides.
d. Install clamp.
e. Tighten clamp. Torque to 35 lb-in. (4 Nm).
d
a - Exhaust Tube
b - Clamp
c - "Side" Marking
d - Exhaust Tube
e - Grounding Clip
CAUTION
e
22184
c
a b
GENERAL
22184
Page 7A-5