SERVICE MANUAL NUMBER 23
Preparation
1. Disconnect battery cables from battery.
2. Remove instrument panel harness connector plug from engine harness receptacle after
3. Using wrench to stabilize brass coupling at fuel inlet, loosen fuel line fitting, disconnect
4. Disconnect throttle cable and retain locknuts and hardware.
5. Disconnect shift cable from transmission.
6. Disconnect seawater inlet hose from engine.
7. Disconnect exhaust system hoses.
8. Disconnect any grounding wires and accessories that are connected to engine.
9. Disconnect propeller shaft coupler from transmission output flange.
Be careful when working on fuel system. Gasoline is extremely flammable and
highly explosive under certain conditions. Do not smoke or allow spark or open
flame in area. Wipe up any spilled fuel immediately.
Removal
Center lifting eye (located on top of thermostat housing) is used for engine align-
ment only. DO NOT use to lift entire engine.
DO NOT allow lifting sling to hook or compress engine components or damage to
them will occur.
1. Support engine with suitable sling through lifting eyes on engine.
Index
Index
90-861326--1 MARCH 1999
Downloaded from
https://needmanual.com/
loosening clamp.
and suitably plug fuel line to prevent fuel in tank from leaking into bilge.
a -
Suitable Sling
b -
Engine Lifting Eyes
MIE MODELS - VELVET DRIVE TRANSMISSION
WARNING
CAUTION
CAUTION
a
b
b
75505
Page 2C-3