Mercury MerCruiser MCM 454 Mag MPI Service Manual page 150

MCM MODELS - BRAVO AND BLACKHAWK DRIVES WITH DRIVESHAFT EXTENSION
3. Install cable end guide on throttle lever, then push cable barrel end lightly toward throttle
lever end. (This will place a slight preload on shift cable to avoid slack in cable when
moving remote control lever.) Adjust barrel on throttle cable to align with hole in anchor
plate. Ensure hole in barrel positions cable as shown.
4. Secure throttle cable with hardware as shown and tighten securely.
5. Place remote control throttle lever in the wide open throttle (W.O.T.) position. Ensure
that throttle plates are completely open.
6. Return remote control throttle lever to idle position and ensure that throttle shutters are
completely closed.
b
Index
Page 2B-18
Downloaded from https://needmanual.com/
a - Cable Barrel
b - Anchor Plate
d
c
a - Cable End Guide
b - Cable Barrel
c - Bolt
d - Locknut
e - Throttle Lever
f - Flat Washer and Locknut
g - Throttle Plates
b
71761
SERVICE MANUAL NUMBER 23
a
71711
g
e
a
f
75143
90-861326--1 MARCH 1999