PUMP
Low Pressure Hose (Control Valve-to-Cooler)
REMOVAL
NOTE: Catch fluid that drains from hose, cooler and pump in a suitable container.
1. Loosen hose clamp and remove hose from fluid cooler.
2. Remove fitting from control valve at transom. Remove hose.
INSTALLATION
Route hoses exactly as shown below. This will help avoid stress on the hose fittings
and will help avoid kinks in the hoses.
IMPORTANT: Be careful to not cross-thread or over-tighten hose fittings.
1. Position hose properly (as prior to removal) Install fitting and torque to 23 ft. in. (31 N·m).
Do not cross-thread or overtighten.
Index
Page 9A-14
Downloaded from
https://needmanual.com/
a -
Hose
a -
Power Steering Hose Fitting
a -
Power Steering Hose Fitting
a
a
CAUTION
a
SERVICE MANUAL NUMBER 23
75595
73860
73860
90-861326--1 MARCH 1999