Mercury MerCruiser MCM 454 Mag MPI Service Manual page 434

SERVICE MANUAL NUMBER 23
NOTE:
equipped with MerCruiser Sterndrive, BROWN/WHITE wire is connected to trim sender
terminal block. If installing on MerCruiser Inboard, BROWN/WHITE wire is taped back at
engine end, or it may be used for an accessory (limit 5 amperes).
NOTE:
draw of the primary station and secondary station MUST NOT exceed 35 amperes.
NOTE:
to connection and slide rubber sleeve over connection.
Index
90-861326--1 MARCH 1999
Downloaded from https://needmanual.com/
1
BROWN/WHITE wire is taped back at instrument end. If installing on boat that is
2
An accessory fuse panel may be connected at this location. The combined current
3
Connect wires together with screw and hex nut. Apply Quicksilver Liquid Neoprene
A - Secondary Station
1 - Start - Stop Panel
2 - Tachometer
3 - Oil Pressure
4 - Water Temperature
5 - Battery Meter
B - Primary Station
1 - Ignition Switch
2 - Tachometer
3 - Oil Pressure
4 - Water Temperature
5 - Battery Meter
6 - To Engine
7 - 20 Ampere Fuse
WIRING DIAGRAMS
Page 4E-23