Take-Up Roller Replacement; About; Procedure - Precor GEN06 Series Service Manual

Take-Up roller Replacement

About

This procedure provides instruction to remove and replace the Take-Up roller.
CAUTION: Two running belt gauges, Precor part number 20007-101, are required.
It is important that this procedure be followed to maintain correct drive belt and run-
ning belt tension. Improper tensioning of the belt will lead to premature running belt
wear, premature driver roller bearing failure and premature Take-Up roller bearing
failure.

Procedure

Review entire procedure before starting.
1. Switch the input power OFF and
2. Remove the front hood.
3. Remove the end cap and belt guard covers (see
ment" on page
4. Remove the left and right deck trim covers.
Removal Instructions
5. Remove running belt tension by alternately loosening the left and right Take-Up roller
mounting/adjustment bolts. Remove the mounting bolts, lift and slide the Take-Up roller
out of the running belt.
Installation Instructions
1
Disconnect a device power cord plug or cable connector from the power receptacle or outlet.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
unplug
66.
1
the power cord.
"End Cap & Belt Guard Cover Replace-
6 Replacement Procedures
Take-Up roller Replacement
Page 86