Table of Contents
Advertisement
Data point
Symbols
Abbreviations
Technical abbreviations
Note
12/148
Siemens Building Technologies
HVAC Products
A data point is a process image element. It is displayed in ACS and is read-only or is
read/write.
The user level selected in ACS determines whether a data point is read-only or
read/write.
Symbols in the ACS screenshots used for this document:
= Operating page, 1
(in this document, we refer to the menu tree item as "operating page").
= Operating page, 2
= Data point at the service level.
= Data point at the end user level.
= Read/write data point; the setting value can be changed.
= Read/write reference data point; the setting value can be changed. Other data
points are displayed depending on the setting value.
= Read-only data point; the value cannot be changed.
= Read-only reference data point; the value cannot be changed. Other data
points are displayed depending on the value.
ACS Plant operating software ACS7...
DP
Data point, ref. DP = Reference data point.
FB
Function block, see configuration diagrams in the Appendix, Section 7.3.
KNX Konnex
AT+
Extended command language for modems: Attention+
GSM Global System for Mobile communication
ISDN Integrated Services Digital Networks
SMS Short Message Service
SMTP Simple Mail Transfer Protocol
TAP
Telocator Alphanumeric Protocol
UCP Universal Computer Protocol
See Section 7.2.9 for information on technical terms and abbreviations.
Commissioning instructions OZW775 V2.01
Overview
st
operating level of the device
nd
and lower operating levels of the device.
CE1C5663en
22.06.2012
Advertisement
Table of Contents
