Siemens Synco ZW775 V2.0 Commissioning Instructions page 17

Step Section
9 4.3
(continued)
4.3.2
Siemens Building Technologies
HVAC Products
Description
Application [ Parameter Setting ]
Data points in the "Settings" operating page
Command sequence:
Settings > Message receiver
> Message receiver
*) Data points in italics are displayed depending on the data point configuration for "Receiver type",
"Interface", "Modem type", "Transmission protocol".
Command sequence:
Settings > System report
> Inputs
> Inputs
*) Data points in italics are displayed depending on the data point configuration for "Input identifier".
Command sequence:
Settings > Inputs
> Time switches
Command sequence:
Settings > Meter *)
> Operating hours**)
*) The command sequences Meter >Meter 1...8 (Pulse meter 1...8) and the corresponding data
points are displayed only if e.g. data point "N.X4 = Pulse" was parameterized via Extra
configuration > Input identifier, and e.g. data point "Input 4 = N.X4" via Extra configuration > Meter.
**) The command sequences Operating hours > Operating hours 1...5 (Hours run counter 1...5) and
the corresponding data points are displayed only if e.g. data point "Input 5 = N.D5" was
parameterized via Extra configuration > Operating hours".
Commissioning instructions OZW775 V2.01
Recommended commissioning
Data points
> Message receiver 1 Message receiver 1
Receiver type
Interface*)
Transmission protocol
Fault priority
E-mail address
Address ACS alarm
Port number ACS alarm
Message repetition
Phone number receiver
Phone number provider
Hardware settings
Display format
Service number
Receiver key word
> Message receiver 2..3 same as Message receiver 1
Data points
Signal time
Message cycle
Fault priority
> N.X1 N.X1
Normal position *)
Text for: Logic 0
Text for: Logic 1
Type
Correction
Value low
Value high
> N.X2...8 same as N.X1
Data points
> N.D1 N.D1
Normal position
Text for: Logic 0
Text for: Logic 1
> N.D2...8 same as N.D1
Time switch 1...4
[Time switch 1...4] Invert. Relay
Data points
> Meter 1. Meter 1
Pulse unit
Pulse valency numerator
Pulse valency denominator
Overflow value
> Meter 2...8 same as Meter 1
> Operating hours 1 Operating hours 1
Service interval
Message triggering
Text for: Service required
Text for: Service done
> Operating hours 2...5 same as Operating hours 1
17/148
CE1C5663en
22.06.2012