Siemens Synco ZW775 V2.0 Commissioning Instructions page 16

Step Section
8 4.2
4.2.1
4.2.2
4.2.3
9 4.3
4.3.1
4.3.2
16/148
Siemens Building Technologies
HVAC Products
Description
Central communication unit data points
Examples for data point value changes
Select the data point and double-click it to open the dialog box.
−
Change the values and click
−
Data point description
The following are displayed: Default value, setting value(s) and explanations.
−
Inputs/outputs, function blocks, interfaces
The terminal and function block inputs/outputs play a key role in parameterization.
−
See below for data points of the operating page "Commissioning" > "Extra
configuration".
Application [ Parameter Setting ]
Data points in the "Commissioning" operating page
Command sequence:
Commissioning > Basic configuration
> Extra configuration
Data points in the "Settings" operating page
Command sequence:
Settings > Central communication unit
> Time of day/date
> Communication
Konnex
Commissioning instructions OZW775 V2.01
Recommended commissioning
to enter the changed value.
OK
Data points
Basic configuration
> Input identifier N.X1...N.X8
> Time switch [Time switch 1...4] relay
[Time switch 1...4] op selector
> Meter Input 1...8
Displayed unit
Displayed format
> Operating hours Input 1...5.
> Faults Fault button external
Fault input 1...20
Fault relay 1...2
> Message receiver Message inhibition
Data points
Language
Code
Time synchronization
Time zone
Mains frequency
> Konnex Decentral bus power supply
Clock time mode Konnex
Remote setting clock slave
> Ethernet IP address
IP subnetwork address
Default gateway
DNS server 1
DNS server 2
UPnP localization
MAC address (read-only)
> E-mail Address mail server
Port number mail server
E-mail address sender
Authentication mail server
User name
Password
> USB UPnP localization
> Modem Modem type
Fax protocol
Baud rate RS-232
Command abortion connection
Reset command
Initialization command
Command opening connection
Command closure
Modem message interval
CE1C5663en
22.06.2012