Table of Contents
Advertisement
Message receiver
Message receiver
114/148
Siemens Building Technologies
HVAC Products
6.4.2 Information from your network administrator
Contact the network administrator for the following data point setting values to enable
the web server OZW775 to send fault messages and system reports via Ethernet to
PC/laptops with installed program "ACS Alarm". See Section 4.3.2 for information on
the data points.
Command sequence: Settings > Message receiver > Message receiver 1...4
Data point
Address ACS alarm
Default val:
acs.example.com
Setting val:
Network admin.
Port number ACS alarm
Default val:
49194
Setting val:
1...65535
Network admin.
6.4.3 Message receiver for ACS Alarm
Configure the following data points in FB "Message receiver" for receivers 1...4 to send
fault messages and system reports to PC/laptops (1...4 depending on the number of
PC/laptops with installed program "ACS Alarm").
Command sequence: Settings > Message receiver > Message receiver 1...4
Data point
Message receiver 1...4
Default val:
(Blank)
Setting val:
Name
Receiver type
Default val:
---
Setting val:
ACS Alarm
Interface
Default val:
USB
Setting val:
Ethernet*
Transmission protocol
Default val:
ACS protocol
Setting val:
ACS protocol
Fault priority
Default val:
All
Setting val:
All, Only urgent
faults
* ACS alarm via Ethernet from ACS CD V5.10
Commissioning instructions OZW775 V2.01
Communication via Ethernet
Information from your network administrator
Settings for IP address or name (domain), max. 20
alphanumeric characters.
..........................................................................
Port number 49194 (must not normally be changed).
Setting if not default:
..........................................................................
Project information
Name (text, max. 20 alphanumeric characters).
..........................................................................
Only the following setting value applies to ACS Alarm:
Receiver type = ACS Alarm.
Only the following setting value applies to ACS Alarm
via Ethernet:
Interface= Ethernet.
Only the following setting value applies to ACS Alarm
via Ethernet:
Transmission protocol = ACS protocol.
Valid "All" or "Only urgent". Setting if not default:
..........................................................................
CE1C5663en
22.06.2012
Advertisement
Table of Contents
