Nortel Modular ICS 6.0 Manual page 249

Pick up receiver
Priority> 221
BLOCK
Release a call
Use line pool?
YES
Hold or release
Release calls
Line in use
P0992640 03
You have used the Call Queuing feature
without picking up the receiver. Auto
Handsfree has not been assigned to your
telephone. You must use the receiver or
answer a call.
You are receiving a priority call. If you are
on another call, inform the person you are
speaking to that you are about to put the
call on hold. Press the flashing line
indicator of the priority call or wait until the
call connects automatically (eight
seconds). The priority call goes through
when you hear the next beep. Your active
call is placed on Exclusive Hold. It is
reconnected automatically when the
priority call ends, unless you transfer the
priority call, in which case you must press
the line button of your original call to
reconnect). Use DND (
BLOCK to reject a priority call.
You have no free line buttons on which to
receive a call. Release one of your current
calls and try again to answer the incoming
call.
You have received a Ring Again offer for a
NO
line pool. Press the flashing internal line
button or YES to use the line pool. On the
M7100 and T7100 sets, just lift the
receiver. Otherwise, press NO or wait 30
seconds for the Ring Again offer to expire.
You cannot program a feature button while
you are on a call.
You have tried to use a feature while you
were on a call or had calls on hold. Release
the call or calls, before using the feature.
The line is in use. Make the call using
normal methods or wait until the line is free.
Common feature displays / 249
the button marked Handsfree/Mute to
Modular ICS 6.0 System Coordinator Guide
²
° fi ) or press