Table of Contents
Advertisement
User Preferences
The User Preferences section of programming allows you to
program memory buttons, speed dial codes and other settings
for any Norstar telephone on the system.
For example, an employee may want to have the Do Not
Disturb feature programmed onto a memory button or create a
speed dial code. Instead of programming from the each
specific set, you can go into programming on the telephone
nearest you to make the change.
Using User Preferences
² ¥ ¥ è ê ä å
1. Press
2. Enter your System Coordinator or Basic password (the
default passwords are
Û Û à Ý Û
By using a Basic password, it is possible to have someone else
do day-to-day upkeep of the telephone programming without
giving out access to sensitive programming. See Using
passwords on page 214.
After you enter the proper password, the display shows you the
telephone with the lowest internal number followed by its
name (For example, 221:Reception).
1. Press ' to move through all the telephones on the
system.
2. Press ≠ when you see the telephone you want to
change. The display reads the model number of the
telephone at the extension.
The display shows Connect set if no telephone is
P0992640 03
² ¥ ¥ ¡ à Ü à
(
Û Ü ß Ý ß
) .
and
Modular ICS 6.0 System Coordinator Guide
) .
Advertisement
Table of Contents
