Programming The Overflow Set - Nortel Modular ICS 6.0 Manual

4. Press ' until the display shows System
prgrming.
5. Press ≠. The display shows Hunt groups.
6. Press ≠. The display shows Show group.
7. Enter the Hunt Group number you want to program (1-30).
8. Press ≠. The display shows Member DNs:.
9. Press ' until the display shows Q Timeout:.
10. Press CHANGE to set the queue time-out: 15, 30, 45, 60,
120, 180.
¨
11. Press

Programming the overflow set

This setting allows you to program the overflow set to which
the Hunt Group calls are to be routed. Unless the overflow
position is a Hunt Group set, the call ceases to be a Hunt Group
call. If the overflow set is a Hunt Group set, the call is treated
as a new call and goes to the bottom of the queue.
The overflow set can be a set DN number associated with a
voice mailbox.
1. Place the appropriate programming overlay on the set you
are using to do programming.
² ¥ ¥ Û ß ß Ü Ý Ý
2. Press
display shows Password:.
Û Ü ß Ý ß
3. Press
Terminals&Sets.
4. Press ' until the display shows System
prgrming.
5. Press ≠. The display shows Hunt groups.
P0992640 03
to exit or ' to continue programming.
(ADMIN). The display shows
Programming Hunt Groups / 171
( CONFIG). The
Modular ICS 6.0 System Coordinator Guide