Set Port Poe - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set port poe

Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — WX1200 10/100 Ethernet ports support half-duplex and
full-duplex operation.
Examples — The following command disables autonegotiation on ports
3 and 5:
WX1200# set port negotiation 3,5 disable
The following command enables autonegotiation on port 2:
WX1200# set port negotiation 2 enable
Enables or disables Power over Ethernet (PoE) on ports connected to MAP
access points.
CAUTION: When you set the port type for MAP use, you can enable PoE
on the port. Use the WX switch's PoE to power 3Com MAP access points
only. If you enable PoE on ports connected to other devices, damage can
result.
Syntax — set port poe port-list enable | disable
port-list — List of physical ports. MSS disables or reenables PoE on
all the specified ports.
enable — Enables PoE on the specified ports.
disable — Disables PoE on the specified ports.
Defaults — PoE is disabled on network and wired authentication ports.
The state on MAP access point ports depends on whether you enabled or
disabled PoE when setting the port type. See set port type ap on
page 91.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command does not apply to any gigabit Ethernet ports or
to ports 7 and 8 on the WX1200 switch.
set port poe 87