Set Network-Domain Mode Member Seed-Ip - 3Com Wireless LAN Switch WX1200 Command Reference Manual

280 C 10: N
HAPTER ETWORK
set
network-domain
mode member
seed-ip
D C
OMAIN OMMANDS
Sets the IP address of a Network Domain seed. This command is used for
configuring a WX switch as a member of a Network Domain. You can
specify multiple Network Domain seeds and configure one as the primary
seed.
Syntax —
set network-domain mode member seed-ip ip-addr
[affinity num]
— IP address of the Network Domain seed, in dotted
ip-addr
decimal notation.
— Preference for using the specified Network Domain seed. You
num
can specify a value from 1 through 10. A higher number indicates a
greater preference.
Defaults — The default affinity for a Network Domain seed is 5.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — You can specify multiple Network Domain seeds on the WX
switch. When the WX switch needs to connect to a Network Domain
seed, it first attempts to connect to the seed with the highest affinity. If
that seed is unavailable, the WX attempts to connect to the seed with the
next-highest affinity. After a connection is made to a non-highest-affinity
seed, the WX switch then periodically attempts to connect to the
highest-affinity seed.
Examples — The following command sets the WX switch as a member
of the Network Domain whose seed has the IP address 192.168.1.8:
WX1200# set network-domain mode member seed-ip 192.168.1.8
success: change accepted.
The following command sets the WX switch as a member of a Network
Domain whose seed has the IP address 192.168.9.254 and sets the
affinity for that seed to 7. If the WX switch specifies other Network
Domain seeds, and they are configured with the default affinity of 5,
then 192.168.9.254 becomes the primary Network Domain seed for this
WX switch.