Cli Conventions; Command Prompts; Syntax Notation - 3Com Wireless LAN Switch WX1200 Command Reference Manual

Wireless lan mobility system; wireless lan switch and controller

Hide thumbs Also See for Wireless LAN Switch WX1200:

Table of Contents

CLI Conventions

Be aware of the following MSS CLI conventions for command entry:

"Command Prompts" on page 24

"Syntax Notation" on page 24

"Text Entry Conventions and Allowed Characters" on page 25

"User Globs, MAC Address Globs, and VLAN Globs" on page 26

"Port Lists" on page 28

"Virtual LAN Identification" on page 29

By default, the MSS CLI provides the following prompt for restricted

users. The mmmm portion shows the wireless LAN switch model number

(for example, 1200).

After you become enabled as an administrative user by typing enable

and supplying a suitable password, MSS displays the following prompt:

For information about changing the CLI prompt on a wireless LAN switch,

see "set prompt" on page 54.

The MSS CLI uses standard syntax notation:

Bold monospace font identifies the command and keywords you must

type. For example:

set enablepass

Italics indicate a placeholder for a value. For example, you replace

vlan-id in the following command with a virtual LAN (VLAN) ID:

clear interface vlan-id ip

Curly brackets ({ }) indicate a mandatory parameter, and square

brackets ([ ]) indicate an optional parameter. For example, you must

enter dynamic or port and a port list in the following command, but

a VLAN ID is optional:

clear fdb {dynamic | port port-list} [vlan vlan-id]