Next - 3Com Wireless LAN Switch WX1200 Command Reference Manual

boot> ls
ls Display a list of all commands and descriptions.
help Display help information for each command.
autoboot Display the state of, enable, or disable the autoboot option.
boot Load and execute an image using the current boot configuration
profile.
change Change the current boot configuration profile.
create Create a new boot configuration profile.
delete Delete the current boot configuration profile.

next

Select the next boot configuration profile.
display
dir Display the contents of the specified boot partition.
fver Display the version of the loadable image specified by
device:filename.
version Display HW and Bootstrap/Bootloader version information.
reset Reset the system.
test Display the state of, enable, or disable the tests option.
diag Access the diagnostic command CLI.
next
Examples — To display a list of the commands available at the boot
prompt, type the following command:
Display the current boot configuration profile.
See Also
help on page 631
Activates and displays the boot profile in the next boot profile slot. (For
information about boot profiles, see display on page 628.)
Syntax — next
Defaults — None.
Access — Boot prompt.
History —Introduced in MSS Version 3.0.
Usage — A WX switch contains 4 boot profile slots, numbered
0 through 3. This command activates the boot profile in the next slot, in
ascending numerical order. If the currently active slot is 3, the command
activates the boot profile in slot 0.
next 633