Set Radio-Profile Dtim-Interval - 3Com Wireless LAN Switch WX1200 Command Reference Manual

set radio-profile
dtim-interval
The following command causes radios managed by radio profile radprof3
to issue countermeasures against devices in the WX switch's attack list:
WX1200# set radio-profile radprof3 countermeasures configured
success: change accepted.
Note that when you issue this command, countermeasures are then
issued only against devices in the WX switch's attack list, not against
other devices that were classified as rogues by other means.
Changes the number of times after every beacon that each MAP radio in
a radio profile sends a delivery traffic indication map (DTIM). A MAP
access point sends the multicast and broadcast frames stored in its
buffers to clients who request them in response to the DTIM.
The DTIM interval applies to both the beaconed SSID and the
nonbeaconed SSID.
Syntax —
set radio-profile name dtim-interval interval
name — Radio profile name.
interval — Number of times the DTIM is transmitted after every
beacon. You can enter a value from 1 through 31.
Defaults — By default, MAP access points send the DTIM once after
each beacon.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — You must disable all radios that are using a radio profile before
you can change parameters in the profile. Use the set radio-profile
mode command.
The DTIM interval does not apply to unicast frames.
Examples — The following command changes the DTIM interval for
radio profile rp1 to 2:
WX4400# set radio-profile rp1 dtim-interval 2
success: change accepted.

set radio-profile dtim-interval

357