Set Rf Detect Countermeasures - 3Com Wireless LAN Switch WX1200 Command Reference Manual

556 C 19: RF D
HAPTER
set rf detect
countermeasures
C
ETECTION OMMANDS
Examples — The following command adds client MAC address
11:22:33:44:55:66 to the black list:
WX1200# set rfdetect black-list 11:22:33:44:55:66
success: MAC 11:22:33:44:55:66 is now blacklisted.
See Also
set rfdetect black-list on page 555
display rfdetect black-list on page 538
Enables or disables countermeasures for the Mobility Domain.
Countermeasures are packets sent by a radio to prevent clients from
being able to use a rogue access point.
CAUTION: Countermeasures affect wireless service on a radio. When a
MAP radio is sending countermeasures, the radio is disabled for use by
network traffic, until the radio finishes sending the countermeasures.
Syntax — set rfdetect countermeasures {enable | disable}
enable — Enables countermeasures.
disable — Disables countermeasures.
Defaults — Countermeasures are disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — This command is valid only on the seed switch of the Mobility
Domain.
Examples — The following command enables countermeasures for the
Mobility Domain managed by this seed switch:
WX1200# set rfdetect countermeasures enable
success: countermeasures are now enabled.
See Also
clear rfdetect attack-list on page 534
display rfdetect ignore on page 546
set rfdetect countermeasures mac on page 557