3Com Wireless LAN Switch WX1200 Command Reference Manual page 548

548 C 19: RF D
HAPTER
C
ETECTION OMMANDS
BSSID: 00:0b:0e:00:7a:8a Vendor: 3Com SSID: 3com-webaaa
Type: intfr Adhoc: no Crypto-types: clear
WX-IPaddress: 10.8.121.102 Port/Radio/Ch: 3/1/1 Mac:
00:0b:0e:00:0a:6a
Device-type: interfering Adhoc: no Crypto-types: clear
RSSI: -75 SSID: 3Com-webaaa
WX-IPaddress: 10.3.8.103 Port/Radio/Ch: dap 1/1/1 Mac:
00:0b:0e:76:56:82
Device-type: interfering Adhoc: no Crypto-types: clear
RSSI: -76 SSID: 3Com-webaaa
Two types of information are shown. The lines that are not indented
show the BSSID, vendor, and information about the SSID. The indented
lines that follow this information indicate the listeners (MAP radios) that
detected the SSID. Each set of indented lines is for a separate MAP
listener.
In this example, two BSSIDs are mapped to the SSID. Separate sets of
information is shown for each of the BSSIDs, and information about the
listeners for each BSSID are shown.
The following command displays detailed information for a BSSID.
WX1200# display rfdetect mobility-domain bssid
00:0b:0e:00:04:d1
BSSID: 00:0b:0e:00:04:d1 Vendor: Cisco SSID: notmycorp
Type: rogue Adhoc: no Crypto-types: clear
WX-IPaddress: 10.8.121.102 Port/Radio/Ch: 3/2/56 Mac:
00:0b:0e:00:0a:6b
Device-type: rogue Adhoc: no Crypto-types: clear
RSSI: -72 SSID: notmycorp
WX-IPaddress: 10.3.8.103 Port/Radio/Ch: dap 1/1/157 Mac:
00:0b:0e:76:56:82
Device-type: rogue Adhoc: no Crypto-types: clear
RSSI: -72 SSID: notmycorp
Table 99 and Table 100 describe the fields in these displays.