Saving The Current-Configuration; Erasing Configuration Files From Flash Memory; Configuring The Name Of The Configuration File Used For The Next Startup - 3Com Switch 4500 26-Port Configuration Manual

230 C 12: F S
HAPTER ILE
Saving the
Current-configuration
Erasing Configuration
Files from Flash Memory
Configuring the Name of
the Configuration File
Used for the Next
Startup.
M
YSTEM ANAGEMENT
The configuration files are displayed in their corresponding saving formats.
Use the command to save the current-configuration in the Flash Memory,
save
and the configurations will become the saved-configuration when the system is
powered on for the next time.
Perform the following configuration in any view.
Table 246 Save the Current-Configuration
Operation
Save the current-configuration
After a Fabric is formed, if you execute the
Fabric saves the current configuration to its individual configuration file. If you do
not enter the
file-name
specified the configuration file for booting, the current configurations will be
stored to the specified configuration file; and for the Switches that have not
specified the configuration file for booting, the current configurations will be
stored to the default configuration file, which is sw4500cfg.cfg for Series 4500
Switches.
The
reset saved-configuration
files from Flash Memory. The system will use the default configuration parameters
for initialization when the Switch is powered on for the next time.
Perform the following configuration in User View.
Table 247 Erase Configuration Files from Flash Memory
Operation
Erase configuration files from Flash Memory
You may erase the configuration files from the Flash in the following cases:
After being upgraded, the software does not match with the configuration
■
files.
The configuration files in flash are damaged. (A common case is that a wrong
■
configuration file has been downloaded.)
Perform the following configuration in User View.
Table 248 Configure the Name of the Configuration File used for the Next Startup
Operation
Configure the name of the configuration
file used for the next startup
is the name of the configuration file and its extension name can be
cfgfile
".cfg". The file is stored in the root directory of the storage devices.
After the above configuration, execute
the running of the configuration files, and to verify the effect of the configuration.
Command
save [ file-name | safely ]
save
parameter in this command, for the Switches that have
command can be used to erase configuration
Command
reset saved-configuration
Command
startup saved-configuration
cfgfile
display
command, every switch in the
command in all views to display