Conventions - 3Com CoreBuilder 3500 Getting Started Manual

10 A T G
BOUT HIS UIDE
For information on
Cabling rules and pin
assignments:
System processor serial ports
Fast Ethernet modules
Gigabit Ethernet modules,
including GBIC modules
FDDI modules
Performing system power up and
checking diagnostics LEDs
Deciding how to manage your
system
Setting up your modem
Configuring the IP interface
Diagnosing hardware and
software problems
Environmental and compliance
specifications
Turn to
"Cabling the System Processor
Ports" on page 31
"Fast Ethernet Modules"
beginning on page 34
"Gigabit Ethernet Modules"
beginning on page 37
"Cabling FDDI Modules"
beginning on page 42
"Power Up" beginning on
page 47
"How Do You Want to Manage
the System?" on page 53
"Modem Setup" on page 55
"Configuring the IP Management
Interface" on page 56
"Diagnosing Problems"
beginning on page 60
Appendix A, "System
Specifications"
For information on
Removing and replacing
field-replaceable units
Checking your site for
environmental and safety
considerations
Getting help from your network
supplier or 3Com
Returning 3Com products to
3Com for repair

Conventions

Table 1 and Table 2 list conventions that are used
throughout this guide.
Table 1 Notice Icons
Icon Notice Type Description
Information Information that describes important
Note features or instructions
Caution Information that alerts you to potential
loss of data or potential damage to an
application, system, device, or network
Warning Information that alerts you to potential
personal injury
Turn to
Appendix B, "Field-Replaceable
Components"
Appendix C, "Site Requirements
and Safety Codes"
Appendix D, "Technical Support"
"Returning Products for Repair"
on page 89