To Set Up Blocking Zones (Rx And Tx) - Furuno FV-110GX Operator's Manual

Configuration with the web interface
5.4.2

To set up blocking zones (RX and TX)

On this page you define blocking zones, i.e. NO TX and RX zones, enter azimuth values
and elevation angles for each blocking zone. Azimuth values and elevation angles for
each blocking zone can be entered. To enable a blocking zone you must select Active.
Figure 5-14: Web interface: SETTINGS, Blocking zones — azimuth and elevation
To define and set a blocking zone, do as follows:
1. Select SETTINGS > Blocking zones.
2. Select Active to enable the blocking zone.
5-20