Table of Contents
Advertisement
7.2
Software update
7.2.1
Prerequisites
The following items are required to make a software update:
• One computer with a standard Ethernet port available.
• A standard Internet browser.
• 1024×768 pixels or higher display resolution (best viewed with small fonts).
• One straight LAN cable.
• Access to the file with the new software.
7.2.2
Software update (ADU, ACU)
Note
Software update using the web interface of the ACU
The upload procedure takes a couple of minutes. When done, the ACU automatically
restarts with the new software version. The start-up procedure after a software upload
takes longer than the usual start-up time, as the software in the ADU must also be
updated. This is shown in the ACU display as ANTENNA SW UPLOAD.
To make a software update, do as follows:
1. Power up the FV-110GX system, i.e. switch on the ACU. Wait until the ACU has
finished initializing.
2. Connect a PC to LAN interface 3 (Service port, standard Ethernet) of the ACU or to
the front LAN connector of the ACU.
Figure 7-7: LAN 3 connector used for configuring the FV-110GX
If you want to use another LAN port to access the web interface you must configure it
according to your network requirements. See To configure the LAN network on
page 5-23 for more information.
3. Open your Internet browser and enter the IP address of the ACU. The default IP
address is http://192.168.0.1.
4. The web interface shows the DASHBOARD page.
5. Click SERVICE in the navigation pane. The UPLOAD page is displayed.
Software update should only be done by qualified service personnel.
Software update
7-9
Advertisement
Table of Contents
