Chapter 5 Configuration; Introduction To The Built-In Web Interface; Overview; Connecting To The Web Interface - Furuno FV-110GX Operator's Manual

Configuration
This chapter has the following sections:

• Introduction to the built-in web interface

• Calibration
• Configuration with the web interface
• Keypad and menus of the ACU
• SNMP support
5.1 Introduction to the built-in web interface
5.1.1

Overview

Use the built-in web interface (installation of software is not necessary) of the FV-110GX
ACU to make a full configuration of the FV-110GX. You can use a standard Internet
browser.
For quick start instructions see Calibration on page 5-7.
Important
5.1.2

Connecting to the web interface

To connect to the web interface of the ACU do as follows:
1. Switch on the ACU. Wait until the LEDs on the front plate of the ACU show that the
system is ready to be configured.
• Power LED: Green
• Logon LED: Off
• Fail/Pass LED: Flashing green, during power-on self test, after that steady green.
2. Connect a PC to LAN port 3: Service (standard Ethernet) of the ACU or to the front
LAN connector of the ACU.
The FV-110GX system is not designed to be connected directly to the
Internet. It must be located behind a dedicated network security device such
as a fire wall.
If any ports of the FV-110GX are exposed to the Internet you must change
the default passwords as anyone with access and malicious intent can render
the FV-110GX inoperable.
Chapter 5
5
5-1