To Open And Remove The Service Hatch - Furuno FV-110GX Operator's Manual

2.3.2

To open and remove the service hatch

Through the service hatch you can access the antenna modules. You can remove the hatch
for better mobility when servicing the antenna.
To open the service hatch in order to access the antenna modules do as follows:
For the current antenna
1. Use a Torx TX20 screw driver to remove the two screws locking the latches.
2. Pull open the two latches and let the lid fall open.
If necessary, you can remove the service hatch.
3. Free the service hatch from the nylon loops, move them to the side, one by one.
4. Pull the service hatch free. The service hatch weighs approx. 4.5 kg.
5. When inserting the hatch again follow steps above in reverse order.
Lock the two latches of the service hatch by fastening the two screws in the latches
with a Torx TX20 screw driver to protect the ADU modules against unauthorised
access.
Figure 2-20: To open the service hatch
Figure 2-21: To remove the nylon loops
Installation of the ADU
2-23