Zone - Furuno FV-110GX Operator's Manual

C.2.10

zone

zone
zone <id> azimuth <start
angle> <end angle>
zone <id> elevation <start
angle> <end angle>
zone <id> tx_off <yes | no> Enables or disables TX inside the blocking
zone <id> active <yes | no> Enables or disables the blocking zone.
zone <id>
Command
Table C-11: UCLI command: zone
Description
Shows the sub commands, unit and
description for the command zone.
Sets the azimuth angles of the blocking zone
for one zone.
• Valid zones: 0 to 7
• Valid angles: 0 to 360
Sets the elevation angles for a blocking zone.
• Valid zones: 0 to 7
• Valid angles: 0 to 360
zone.
Shows the setting for the blocking zone.
Supported commands
C-9