Appendix C Command Line Interface; Introduction; Telnet Connection - Furuno FV-110GX Operator's Manual

Command line interface
C.1

Introduction

After you have done the initial configuration and connected the FV-110GX system to
your network, you can use Telnet to configure the FV-110GX system. You can also setup
VSAT modem parameters.
Connect to FV-110GX
using IP address
Figure C-1: How to use the command line interface (example for telnet)
After successful login you can read and change settings. Use the command config
activate to activate the new settings in the ACU. You will need to refresh the browser
window before the changed settings become visible.
Every change is performed on the active satellite profile or the active VSAT
Note
modem profile. Parameter identifiers are case sensitive.
C.1.1

Telnet connection

You can access the command line interface via Telnet.
Access to the FV-110GX system is protected by a user name and password. This is the
same user name and password that is used in the web interface under
ADMINISTRATION.
The interface is on the standard Telnet port 23 or SSH port 22. Use any LAN port and
corresponding IP address of the ACU (except LAN 2 on GX/Ka ACU). To start telnet
session do as follows:
1. Open a Telnet client of your choice.
2. At the prompt, enter the IP address of the ACU, login admin and password.
Read or change settings
Figure C-2: Command line interface, login
Appendix C
C
Write new settings to
FV-110GX
C-1