The Menu Tree - Furuno FV-110GX Operator's Manual

Keypad and menus of the ACU
5.5.3

The menu tree

In the menu tree you can see how the system has been configured. To enter satellite
information directly, use a connected PC and the web interface.
Top-level menu
Top-level
menu
MAIN
ANTENNA
MODEM
NETWORK
5-38
ANT
MAIN
POINTING
POLARIZATION
ANTENNA
GNSS
MODEM
HEADING
NETWORK
VERSIONS
SATELLITE
SERIAL NUMBERS
EVENTS
LOCAL ADMINISTRATION
MODEM
MODEM TYPE
TX ENABLE
RX LOCK
NET LED
STAT LED
TX LED
RX1 LED
SAT
RX2 LED
POSITION PWR LED
RX POLARIZATION TEMP LED
TX POLARIZATION FAN LED
RX FREQUENCY
NETWORK
LNB LO
BUC LO
HOST NAME
PORT 1 IP
PORT 1 MASK
EVENT
PORT 3 IP
PORT 3 MASK
<EVENT 1>
PORT 4 IP
<EVENT 2>
PORT 4 MASK
<EVENT 3>
DEFAULT GATEWAY
<EVENT 4>
Figure 5-27: Antenna Control Unit, menu tree
View with current status of the FV-110GX. Example when
logged on to the satellite:
This view is displayed after a time out of 10 minutes. Press
any key (except left arrow) to enter the menu at MAIN.
New events are shown in this display. If an event is
displayed, press OK to jump directly to the menu EVENTS
for viewing the currently active events.
Shows the current ADU parameters, position, software
version and serial numbers of the ADU and ACU.
Selected VMU type and setup, including signal level.
Shows the IP addresses and netmasks of the LAN
connectors of the ACU and the management mask.
Table 5-15: Top-level menus of the ACU
ANT-1
ANTENNA STATE
ELEVATION
AZIMUTH
ANT-2
RX POLARIZATION
TX POLARIZATION
ANT-3
LATITUDE
LONGITUDE
FIX TYPE
ANT-4
HEADING
ANT-5
SW VERSION
ANT-6
ACU
ANTENNA
Description