Help; Config - Furuno FV-110GX Operator's Manual

C.2.1

config

config
config pending_list Shows the number of pending changes.
config current_list Shows the values for the current satellite profile,
config discard
config activate
C.2.2 demo
Command
demo start
demo stop
demo reset
C.2.3 exit
Command
exit
C.2.4

help

Command
help
help satellite Shows the sub commands and description for the command
Command
Shows the sub commands available, including a short
description.
antenna and some tracking information.
Discards all pending changes.
Use this command to save and activate the pending
changes in the FV-110GX system.
Table C-2: UCLI command: config
Starts a demo pattern where the antenna will turn azimuth,
elevation and cross elevation until it receives the command
demo stop.
Stops the antenna demo pattern.
Resets the antenna to angle 0.
Table C-3: UCLI command: demo
Exits the connection to the FV-110GX system.
Table C-4: UCLI command: exit
Shows a list of commands available, including a short
description.
satellite.
Table C-5: UCLI command: help
Supported commands
Description
Description
Description
Description
C-3