Table of Contents
Advertisement
3.1.3
Permitted mounting positions
The horizontal mounting position is permitted.
Take into account the permitted temperature range for operation that depends on the
mounting position in accordance with the "Technical specifications (Page 59)" section.
Ensure that the following clearances measurements to another component or to a wall of the
enclosure are complied with:
• Underneath of the device at least 100 mm
• Above the device at least 50 mm
3.2
Mounting the device
3.2.1
Mounting instructions
Note
If the equipment is used in a manner not specified by the manufacture, the protection
provided by the equipment might be impaired.
Note the following:
• The device is approved for indoor operation only.
• When the device is used in the area of Industrial Control Equipment in accordance with
IEC/EN/DIN EN/UL61010-2-201, the device is classified as "Open equipment". Open
equipment must be installed within an enclosure which protects you from hazards,
including mechanical hazards, electrical shock and spread of fire.
• Install the device only as one of the described permitted mounting positions.
• For installation of control cabinet, observe the country-specific regulations.
SIMATIC IPC327G
Operating Instructions, 09/2021, A5E51366275-AA
Installing and connecting the device
3.2 Mounting the device
21
Advertisement
Table of Contents
