Program Selection - Siemens SINUMERIK 840D sl Commissioning Manual

General settings

6.11 Program selection

Example
DB60.DBB10 for data block 60, byte 10
Reserves the bytes 10, 11, 12, 13, 14, 15, 16, 17 as HMI monitor
DB60.DBB10: PLC-ID of the active operating area
DB60.DBW12: PLC-ID of the window that is currently selected
Note
When using the HMI monitor, the corresponding variables in the PLC user interface –
DB19.DBB21 and DB19.DBW24 – are no longer supplied.
This means that either the user interface or the HMI monitor can be used – but not both
simultaneously.
6.11 Program selection
6.11.1 Displaying the softkey
The softkeys on the user interface for calling the program lists are activated via general
configuration machine data.
Configuring a softkey
MD51041 $MNS_ENABLE_PROGLIST_USER
0
1
MD51043 $MNS_ENABLE_PROGLIST_MANUFACT
0
1
66
No softkey
The "Prog. list" softkey is displayed
No softkey
The "MANUFACTURER" softkey is displayed
Commissioning Manual, 03/2013, 6FC5397-1DP40-3BA1
SINUMERIK Operate (IM9)